- 您现在的位置：买卖IC网 > Sheet目录311 > AS3642-ZWLT (ams)IC WHITE LED FLASH DRIVER 6WLCSP
set, which can be readout with the interface. The fault bits are cleared by a readout of the fault register.
abled and the bit fault_ovp (see page 19) is set.
compared to the voltage on SCL, the AS3642 will ignore any I C write commands. Therefore the application can simply
AS3642
Datasheet - D e t a i l e d D e s c r i p t i o n
Protection and Fault Detection Functions
The protection functions protect the AS3642 and the LED(s) against physical damage. In most cases a register bit is
3
DCDC Overvoltage Protection
In case of no or a broken LED at the pin LED_OUT and an enabled DCDC converter, the voltage on VOUT rises until
it reaches V VOUTMAX (overvoltage condition) and the voltage across the current source does not reach regulation
(VOUT-V LED < V ILED_COMP ). If this condition is detected, the DCDC converter is stopped, the current sources are dis-
4
DCDC Broken Coil Detection
If the coil L DCDC is broken, the AS3642 is not powered by the pin SW connected to VOUT by the internal switch. Due
to the protection diodes between SCL to VOUT and SDA to VOUT, the AS3642 can be powered through these diodes.
The AS3642 detects this error condition by comparing the voltage on SCL and VOUT. If the voltage on VOUT is lower
2
detect this condition.
Note: Due to the broken coil detection, the high levels of SDA and SCL should be always below the supply voltage.
LED Short Circuit Protection
After the startup of the DCDC converter, the voltage on LED_OUT is continuously monitored and compared against
V LEDSHORT . If the voltage stays below V LEDSHORT , the DCDC is stopped (as a shorted LED is assumed), the current
sources are disabled and the bit fault_led_short (see page 19) is set.
Overtemperature Protection
The junction temperature of the AS3642 is continuously monitored. If the temperature exceeds T OVTEMP , the DCDC is
stopped, the current sources are disabled and the bit fault_overtemp (see page 19) is set. The driver cannot be re-
enabled unless the junction temperature drops below T OVTEMP -T OVTEMPHYST .
Flash Timer
The duration of the flash is defined by the register flash_timer (see page 18) . After the timer expires, the DCDC is
stopped and the flash current source (on pin LED_OUT) is disabled.
Supply undervoltage Protection
If the voltage on the pin VOUT (=battery voltage) is or falls below V UVLO , the AS3642 is kept in shutdown state and in
all registers are set to their default state.
Note: During operation of the DCDC converter, the supply undervoltage protection will still monitor the DCDC output
voltage only. Therefore the supply undervoltage protection will only monitor the battery voltage if the DCDC
converter is switched off and the output capacitor is discharged down to the supply voltage.
Wakeup Circuit - Power off detection
In flash, assist light and indicator mode (register mode (page 18) =01, 10 or 11), if SCL and SDA are L for more than
t TIMEOUT , shutdown mode is automatically entered. This feature automatically detects a power-off of the controlling cir-
cuit driving SCL and SDA (VDD_I/F goes to 0V) - the internal circuit is shown in Figure 19 :
3. Except overtemperature protection bit fault_overtemp : This bit can be cleared once the temperature drops
below T OVTEMP -T OVTEMPHYST .
4. In indicator mode ( mode =01) the register fault_ovp i s never set (the overvoltage protection is nevertheless
operating)
www.austriamicrosystems.com/AS3642
1.2-2
11 - 26
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
AS3643-ZWLT
IC LED DVR CAMERA FLASH 13WLCSP
AS3647-ZWLT
IC LED DVR 1600MA FLASH 13WLCSP
AS3648-ZWLT-500
IC WHITE LED FLASH DVR 13WLCSP
AS3665-ZWLT
IC LED DRIVER SMARTLIGHT 25WLCSP
AS3685B-T
IC DVR PHOTOFLASH 1A 10-DFN
AS3685C-T
IC DVR PHOTOFLASH 1A 10-DFN
AS3691B-ZMFT
IC LED DVR 400MA RGB/WHT 64-MLF
AS3691B-ZTSP
IC LED DVR 400MA RGB/WH 20ETSSOP
相关代理商/技术参数
AS3642-ZWLT-500
功能描述:IC WHITE LED FLASH DRIVER 6WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 特色产品:LM3445 TRIAC Dimmable LED Driver 标准包装:55 系列:PowerWise® 恒定电流:是 恒定电压:- 拓扑:PWM，降压（降压） 输出数:1 内部驱动器:无 类型 - 主要:- 类型 - 次要:高亮度 LED（HBLED） 频率:30kHz ~ 1MHz 电源电压:8 V ~ 12 V 输出电压:- 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:管件 工作温度:-40°C ~ 125°C 产品目录页面:1285 (CN2011-ZH PDF) 其它名称:LM3445M
AS3643-ZWLT
功能描述:IC LED DVR CAMERA FLASH 13WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
AS3643-ZWLT-500
功能描述:IC WHITE LED FLASH DVR 13WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 特色产品:LM3445 TRIAC Dimmable LED Driver 标准包装:55 系列:PowerWise® 恒定电流:是 恒定电压:- 拓扑:PWM，降压（降压） 输出数:1 内部驱动器:无 类型 - 主要:- 类型 - 次要:高亮度 LED（HBLED） 频率:30kHz ~ 1MHz 电源电压:8 V ~ 12 V 输出电压:- 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:管件 工作温度:-40°C ~ 125°C 产品目录页面:1285 (CN2011-ZH PDF) 其它名称:LM3445M
AS3644-ZWLT
功能描述:LED 驱动器 IC 1 输出 DC DC 稳压器 升压（升压） I2C 调光 320mA（闪存） 6-WLCSP（1.5x1.1） 制造商:ams 系列:- 包装:带卷（TR） 零件状态:有效 类型:DC DC 稳压器 拓扑:升压（升压） 内部开关:是 输出数:1 电压 - 供电（最低）:2.5V 电压 -?供电（最高）:5V 电压 - 输出:- 电流 - 输出/通道:320mA（闪存） 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:6-UFBGA，WLCSP 供应商器件封装:6-WLCSP（1.5x1.1） 标准包装:12,000
AS3645A-ZWLT
制造商:ams 功能描述:IC PHOTOFLASH DRIVER 12WLCSP 制造商:ams 功能描述:T&R / WL-CSP12 (2.0x1.5x0.5)
AS3645-ZWLT
功能描述:IC PHOTOFLASH DRIVER 12WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:2,500 系列:- 恒定电流:- 恒定电压:- 拓扑:升压（升压），切换式电容器（充电泵） 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:625kHz ~ 875kHz 电源电压:2.7 V ~ 5.3 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-µMAX 包装:带卷 (TR) 工作温度:-40°C ~ 85°C
AS3646-ZWLT
功能描述:IC LED DRIVER REGULATOR 12WLCSP 制造商:ams 系列:* 零件状态:有效 标准包装:500
AS3647B-ZWLT
功能描述:LED 驱动器 IC 2 输出 DC DC 稳压器 升压（升压） I2C 调光 800mA（闪存） 15-WLCSP 制造商:ams 系列:- 包装:带卷（TR） 零件状态:有效 类型:DC DC 稳压器 拓扑:升压（升压） 内部开关:是 输出数:2 电压 - 供电（最低）:2.7V 电压 -?供电（最高）:4.4V 电压 - 输出:2.8 V ~ 5.5 V 电流 - 输出/通道:800mA（闪存） 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:15-UFBGA，WLCSP 供应商器件封装:15-WLCSP 标准包装:10,000